Which protocol authenticates connected devices before allowing them to access the LAN.


What is a difference between TACACS+ and RADIUS in AAA.


Which statement about the IP SLAs ICMP Echo operation is true.


Which type of interface can negotiate an IP address for a PPPoE client.


Which option is a benefit of switch stacking.


What is the first step you perform to configure an SNMPv3 user.


Which spanning tree feature places a port immediately into a forwarding state.


How can you disable DTP on a switch port.


If host Z needs to send data through router R1 to a storage server, which destination MAC address does host Z us ...


Which Cisco platform can verify ACLs.


Which statement about QoS default behavior is true.


Refer to the exhibit. Router edge 1 is unable to establish OSPF neighbor adjacency with router ISP 1. Which ...


Which statement about MPLS is true.


Which statement about named ACLs is true.


Which two switch states are valid for 802.1w. (Choose two.)


Which option is the benefit of implementing an intelligent DNS for a cloud computing solution.


Which identification number is valid for an extended ACL.


Which two pieces of information are provided by the show controllers serial 0 command. (Choose two.)


Which three options are the HSRP states for a router. (Choose three.)


While you were troubleshooting a connection issue, a ping from one VLAN to another VLAN on the same switch faile ...


Which feature can you use to monitor traffic on a switch by replicating it to another port or ports on the same ...


What is a valid HSRP virtual MAC address.


Which statement about switch access ports is true.


What is the default VLAN on an access port.


What are two enhancements that OSPFv3 supports over OSPFv2. (Choose two.)


Which two states are the port states when RSTP has converged. (Choose two.)


Which process is associated with spanning tree convergence.


Which option describes the purpose of traffic policing.


Which type of topology is required by DMVPN.


What is the best way to verify that a host has a path to other hosts in different networks.


Which protocol supports sharing the VLAN configuration between two or more switches.


You enter the show ipv6 route command on an OSPF device and the device displays a remote route. Which conclusion ...


Which configuration can you apply to enable encapsulation on a subinterface.


Which part of the PPPoE server configuration contains the information used to assign an IP address to a PPPoE cl ...


Which three statements are typical characteristics of VLAN arrangements. (Choose three.)


Which statement about slow inter VLAN forwarding is true.


Which version of SNMP first allowed user based access.


Which two circumstances can cause collision domain issues on VLAN domain. (Choose two.)


Which two components are used to identify a neighbor in a BGP configuration. (Choose two.)


Which EIGRP for IPv6 command can you enter to view the link local addresses of the neighbors of a device.


What are two drawbacks of implementing a link state routing protocol. (Choose two.)


Refer to the exhibit. RTA is configured with a basic configuration. The link between the two routers is operat ...


Which option describes a difference between EIGRP for IPv4 and IPv6.


Which component of the Cisco SDN solution serves as the centralized management system.


Which statement about DTP is true.


Refer to the exhibit. While troubleshooting a switch, you executed the show interface port channel 1 etherchan ...


Which IEEE standard does PVST+ use to tunnel information.


After you configure a new router to connect to a host through the GigabitEthernet0/0 port of the router, you log ...


Refer to the exhibit. Which two statements are true about interVLAN routing in the topology that is shown in t ...


Refer to the exhibit. Which switch in this configuration becomes the root bridge.


Which three statements about HSRP operation are true. (Choose three.)


Which VLAN bridge priority value is assigned by the set span tree root command.


Which purpose of the network command in OSPF configuration mode is true.


Which feature can validate address requests and filter out invalid messages.


Which configuration enables OSPF for network 192.168.1.0/24.


Which command do you enter to view EIGRPv6 adjacencies.


What is the default encapsulation type for Cisco WAN serial interfaces.


Which three checks must you perform when troubleshooting EIGRPv6 adjacencies. (Choose three.)


Which statement about VLAN configuration is true.


From which PPPoE server configuration does a PPPoE client get an IP address.


Routers R1 and R2 are on the same network segment, and both routers use interface GigabitEthernet0/0. If R1 lose ...


Which command do you enter to enable an interface to support PPPoE on a client.


Which three options are types of slow VLAN connectivity. (Choose three.)


Which value can you modify to configure a specific interface as the preferred forwarding interface.


Which WAN technology uses labels to make decisions about data forwarding.


Which two actions must you take to configure a PAgP EthernetChannel between two switches, S1 and S2. (Choose t ...


Which command can you enter to assign an interface to the default VLAN.


Which feature can you use to restrict SNMP queries to a specific OID tree.


Refer to the exhibit. While you troubleshoot a connectivity issue to a PC behind R1, you enter the show access ...


Refer to the exhibit. A technician has configured the FastEthernet0/1 interface on Sw11 as an access link in VL ...


After you configure a GRE tunnel between two networks, the tunnel comes up normally, but workstations on each si ...


Which type does a port become when it receives the best BPDU on a bridge.


Refer to the exhibit. How will the router handle a packet destined for 192.0.2.156.


Which VLAN bridge priority value will make a switch as root for a given VLAN from the below options by the spann ...


Which two statistics appear in show frame relay map output. (Choose two.)


Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end to ...


At which layer of the OSI model does PPP perform.


The command show frame relay map gives the following output: Serial 0 (up): ip 192.168.151.4 dlci 122, dynamic, ...


What can be done to Frame Relay to resolve split horizon issues. (Choose two.)


What are three reasons that an organization with multiple branch offices and roaming users might implement a Cis ...


Which command is used to enable CHAP authentication, with PAP as the fallback method, on a serial interface. ...


What is the result of issuing the frame relay map ip 192.168.1.2 202 broadcast command.


Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has builtin securit ...


Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers.


Which purpose of the network command in the BGP configuration of a router is true.


A network administrator needs to configure a serial link between the main office and a remote location. The rout ...


Which PPP subprotocol negotiates authentication options.


Refer to the exhibit. Assuming that the entire network topology is shown, what is the operational status of th ...


Which two statements describe the process identifier that is used in the command to configure OSPF on a router. ...


Refer to the exhibit. Given the output from the show ip eigrp topology command, which router is the feasible s ...


Which three of these statements regarding 802.1Q trunking are correct. (Choose three.)


Which two options are valid WAN connectivity methods. (Choose two.)


Refer to the exhibit. Which WAN protocol is being used.


What occurs on a Frame Relay network when the CIR is exceeded.


What are two characteristics of Frame Relay point to point subinterfaces. (Choose two.)


Which two statements about using the CHAP authentication mechanism in a PPP link are true. (Choose two.)


Which command allows you to verify the encapsulation type (CISCO or IETF) for a Frame Relay link.


What is the purpose of Inverse ARP.